Developed for the roller chain style drive in the new Dyna Glide series engines For use with stock HD hydraulic lifters 26H Bolt-in cam for 88-95 inch engines with stock compression ratio Great for two up riding, adds torque & HP to the lower & middle RPM ranges Same grind as the TW26

Bolt-in four-cam set More horsepower and torque Stock springs are good to 7000 rpm, requires no headwork Made in the U.S.A. Intake: Open: 34 degrees Close: 40 degrees Duratt

Eliminate spring powered chain adjustersEngines converted to 2007 type cams and chain drives will have higher output due to less power loss from older spring powered chain tensioners. Instead of the original spring adjusters, new roller cam chains use engine oil pressure to maintain proper chain tensionCamshafts on all 99-06 Twin Cam 88 engines (exc. 2006 Dyna) can be updated to new style roller chain drivesDesigned for use with stock H/D hydraulic liftersInstalling 2007 roller cam chains on earlier engines requires series N Andrews camshafts Stock H-D parts are required: 2007 cam support plate, 2007 or later oil pump, cam sprockets and chains and both hydraulic chain adjustersMatching EZ-install pushrods kits are sold separately. EZ-install pushrods do not require removal of gas tanks... Less

You will get more mid-range and top-end power for your street or drag bike These cams work with solid or hydraulic lifters, and the idle remains unaffected up to 6000 rpm with stock valve springs B2 Grind Cam Streee

andrews 2 gear performance gear set for 1999-2006 harley-davidson twin cam motors (except 2006 dyna's)

Performance cams designed by Andrews for XL 883, 1100 and 1200 Evolution 86-90 models Cams run up to 6000 rpm with stock hydraulic lifters; for this reason, it is recommended that solids NOT be installed V2 cams are bolt-ins ff

You'll get more mid-range and top-end power for your street or drag bike These cams work with solid or hydraulic lifters, and the idle remains unaffected up to 6,000 rpm with stock valve springs J GRIND CAMS

You'll get more mid-range and top-end power for your street or drag bike These cams work with solid or hydraulic lifters, and the idle remains unaffected up to 6,000 rpm with stock valve springs J GRIND CAMS

You will get more mid-range and top-end power for your street or drag bike These cams work with solid or hydraulic lifters, and the idle remains unaffected up to 6000 rpm with stock valve springs A2 Grind Cam Shovee

Andrews Products was founded in the spring of 1972 and for 30+ years has specialized in making camshafts and transmission gears for the performance motorcycle market. Performance cams designed by Andrews for XL 883, and 1200 Evolution 00-033